Graco Pro Xpc 24Y307, Инструкция по эксплуатации

Страница: 34 / 60

Setup
PARAMETERS
Setup
Screen
Display
(A1)
Value
Description Display (A3) Values Display
(A4)
Value
5 P05 Reserved
This selection is not implemented in this version of
the controller.
0: Reserved rES1
6 P06 CAN Purpose ID
Use to set the purpose ID for CAN communications. 0-31
0 (default) variable
7 P07 Log level
Display A2: LoG
Use to designate how much information is logged
in the system.
0–5
2 (default) LoG
CONFIGURATION
Setup
Screen
Display (A1)
Value
Description Display (A2) Values
8 C0 Arc detection rate of change set point averaging
interval Δt [sec]
Use to set the time interval that the controller will use to
calculate the spraying current / voltage rate of change.
0.01 – 1.00 by 0.01
0.01 (default)
9 C1 Arc detection blanking time setpoint [sec]
Use to set the amount of time after turning on the high
voltage during which arc protection is suppressed.
0.0 – 2.0 by 0.1
0.5 (default)
10 C2 Discharge timer setpoint [sec]
Use to set the time needed to fully discharge after
turning off the high voltage. After the timer expires,
the controller pulls the Electrostatic Discharge Output
high.
0.0 – 60.0 by 0.1
0.0 (soventborne default)
30.0 (waterborne default)
11 C3 Voltage Change Interval [sec]
Use to set the interval of transition time between
high voltage set points. This setting may be required
depending on arc detection settings.
0.0 – 5.0 by 0.1
0.0 (default)
34 333266D