Graco My Ride 65, Инструкция по эксплуатации

Страница: 81 / 88

81
9 Additional
Information
How to Lock Your Lap and Shoulder Vehicle Seat Belt
Sliding Latch Plate and Switchable
Retractor
A latchplate that slides freely on the belt webbing and
cannot, by itself, hold the belt snug around a car seat.
When installing the car seat, route the vehicle seat belt
through the proper belt path and buckle it in. Slowly
pull the shoulder belt all the way out to switch it to
locking mode. Then, as you pull the vehicle seat belt
tight, feed all the slack back into the retractor.
Grab the sides of the seat at the belt path and slide the
seat side-to-side and front-to-back. The seat should not
move more than 1” (2.5 cm).
Note: With the vehicle seat belt in this locking mode, all the tension is upwards in the shoulder belt. This may
start to tilt your car seat sideways. If this happens, use a locking clip instead of this switching the retractor.
See Sliding Latch Plate and ELR Retractor.