DataTrak Operation
28
312798J
Prime/Flush
1.
See F
IG
. 9. To enter Prime/Flush mode, press any
key to wake up the display, then press
. The
Prime/Flush symbol will appear in the display and
the LED will flash
.
2.
While in Prime/Flush mode, runaway protection is
disabled and the batch totalizer (BT) will not count.
The grand totalizer (GT) continues to count.
3.
To exit Prime/Flush mode, press any key to wake up
the display, then press
. The Prime/Flush sym-
bol will disappear from the display and the LED will
stop flashing.
Counter/Totalizer
See F
IG
. 9. The last digit of the batch totalizer (BT) rep-
resents tenths of gallons or liters. To reset the totalizer,
press any key to wake up the display, then press and
hold
for 3 seconds.
•
If AC is set to gallons or ounces, BT and GT dis-
play gallons.
•
If AC is set to liters or cc, BT and GT display
liters.
•
If AC is set to cycles, BT and GT display cycles.
Press
to toggle between flow rate units and cycles.
A letter under the BT display indicates that both BT and
GT are displaying gallons (g) or liters (l). No letter
means both BT and GT are displaying cycles.
Display
See F
IG
. 9. The display (AE) will turn off after 1 minute
of inactivity in Run mode or 3 minutes in Setup mode.
Press any key to wake up the display.
NOTE: DataTrak will continue to count cycles when dis-
play is off.
NOTE: The display (AE) may turn off if a high-level static
discharge is applied to the DataTrak. Press any key to
wake up the display.
Diagnostics
DataTrak can diagnose several problems with the pump.
When the monitor detects a problem, the LED (AD, F
IG
.
9) will flash and a diagnostic code will appear on the dis-
play. See Table 1.
To acknowledge the diagnosis and return to the normal
operating screen, press
once to wake up the display,
and once more to clear the diagnostic code screen.
