Graco Lube Master, Инструкция по эксплуатации

Страница: 23 / 44

Maintenance and Repair
3A2781B 23
Pump Drive Repair Kit 563915
See instructions included with repair kit for procedure.
Output Manifold Repair Kit 563916
See instructions included with repair kit for procedure.
Seal Repair Kit 563921
See instructions included with repair kit for procedure.
Post Maintenance
After pump maintenance is completed, perform the fol-
lowing to return the unit to service:
1. Place the pump body and assembled parts from
where it was removed and secure with attaching
hardware. Tighten all fasteners to the proper torque.
2. Install all guards and mechanical linkages or con-
nections that were removed from the pump drive
shaft.
3. Connect the power source to the pump package.
4. Replace the drain plug (116).
Clutch Drive Maintenance
There is little maintenance required on the clutch drive.
The clutch drive assembly replacement part number
563383 is available from Graco. Contact your local
Graco distributor for assistance in ordering this part.
Recommended Lubricants for
Enclosed Gear Reducers
The gear reducer requires 7.8 oz (230.7 ml) of clean
lubricant as listed above.
The lubricant must remain free from oxidation and con-
tamination by water or debris, since only a very thin film
of oil stands between efficient operation and failure. To
assure long service life, the reducer should be periodi-
cally drained (preferably while warm) and refilled to the
proper level with a recommended gear oil. Under normal
environmental conditions oil changes are suggested
after the initial 250 hours of operation and thereafter at
regular intervals of 2500 hours or every 6 months.
Synthetic lubricants allow extended lubrication intervals
because of increased resistance to thermal and oxida-
tion degradation. It is suggested that the initial oil
change be made at 1,500 hours, with additional oil
changes scheduled at 5,000 hour intervals.
Alternative AGMA Lubricants
AMBIENT
(Room)
TEMP RECOMMENDED
OIL (or equiva-
lent) VISCOSITY
RANGE SUS
@ 100° F
(38°C) LUBRI-
CANT
AGMA NO. ISO
VISCOSITY
GRADE NO.
+
-30° to 225° F**
(-34° to 107°C) MOBIL SHC 634*
SYNTHETIC 1950/2150 --- 320/460
40° to 90° F
(4.4° to 32.2°C) MOBIL 600W
CYLINDER OIL 1920/3200 7 or 7C 460
80° to 125° F
(26.7° to
51.7°C) MOBIL EXTRA
HECLA SUPER
CYLINDER OIL 2850/3600 8 or 8C 680
MANUFACTURER LUBRICANT NAME AGMA RATING
Getty Refining Co.
Getty Refining Co.
Getty Refining Co. Veedol Asreslube 98
Veedol Asreslube 95
Veedol Asreslube 90 8 EP
7 EP
6 EP
Lubrication Engr.
Inc.
Lubrication Engr.
Inc. Almasol 609
Almasol 608 8
7
Mobil Oil Corp.
Mobil Oil Corp.
Mobil Oil Corp. Mobilgear 634
Mobil Extra Hecia Super
Mobil Cylinder 600W 8 EP
8
7
Shell Oil Co.
Shell Oil Co.
Shell Oil Co. Omala 460
Valvala J460
Omala 680
Valvala J680 7 EP
7
8 EP
8
Texaco Inc.
Texaco Inc. Meropa 680
Meropa 460 8 EP
7 EP