Auto-Layout Can Actuator Adjustment
12
312226P
Auto-Layout Can Actuator Adjustment
Adjustments
The can actuator is set at the factory. If the dot size is
not as desired, do the coarse and/or fine adjustments.
Coarse Adjustment
1
Locate four screws on side of holder base.
2
Loosen screws to allow holder base to move freely.
Do not aim aerosol can at your face.
3
Move holder base until solenoid cartridge bar is
approximately 0.10 in. (thickness of two dimes) from spray tip.
4
Carefully tighten screws. Verify gap.
Fine Adjustment
If coarse adjustment did not achieve desired dot size,
proceed as follows:
1
Start striper and move to
PARKING MODE
display.
2
Set
DOT SIZE
setting to smallest size (least amount of
bars on display). Press arrow keys to increase/decrease
size.
3
Do
Coarse Adjustment
steps 1 and 2. Move holder base
until a dot size of approximately a dime is achieved.
Tighten screws on holder base.
ti10070a
ti10071a
ti10072a
ti10073a
MODE
SETUP
STALL SIZE 9.00’
0 mph
DOT SIZE
PARKING MODE
ti9919a
Good Dot
Poor Dot with Ghosting
ti10379a
ti10380a
