Determining Bead Application Pressure
28
332230T
Filling Bead Hopper
1. Move compressor bypass switch (9) to horizontal
position to disengage compressor or turn engine off.
2. Release pressure on bead tank to 0 psi (0 bar, 0
MPa). Turn pressure relief valve (8) to vertical
position and watch bead tank pressure gauge (3)
until pressure reads 0 psi (0 bar, 0 MPa). Do not use
safety valve (3) to release pressure from bead tank.
3. Loosen wing nut (2) until it reaches end of threads.
If any remaining pressure is in bead tank, it will be
released through seal while wing nut secures lid to
hopper. Confirm pressure is at 0 psi (0 bar, 0 MPa)
and open lid.
4. Place funnel (1) into opening. Pour beads into
hopper. Beads should not be filled to a height
higher than shown in figure below. Bead level can
be viewed through tank wall if light is present.
5. Secure lid over opening and tighten wing nut until
lid is level with hopper.
ti21074a
9
ti21075a
ti21081a
3
8
ti21077a
2
ti21076a
1
ti21080a
Содержание LineLazer 200DC
Страница 31: ...Notes 332230T 31 Notes ...
Страница 32: ...Parts Model 25R268 32 332230T Parts Model 25R268 ...
Страница 34: ...Parts Model 25R270 34 332230T Parts Model 25R270 ...