Installation
10
334627K
Flush
NOTE:
Do NOT cycle the module until the temperature
setpoint has been achieved. Cycling the module below
the temperature setpoint may cause premature seal
leakage.
1.
Disconnect or turn off the device, which triggers the
solenoid valve.
2.
Ensure the nozzle (Z) is removed. See
Figure 9
.
3.
Heat the system to working temperature.
4.
Place a waste container under the applicator to
catch the adhesive.
5.
Press the manual override switch (M) to manually
trigger the solenoid valve.
6.
Dispense hot melt (adhesive) until it is clean.
Install Nozzle
Use a 1/2 in. wrench to install the nozzle. See
Kits and
Accessories
on page
Select RTD
NOTE:
For InvisiPac system only.
Identify the RTD type used in the applicator on the
system’s Advanced Display Module (ADM). The RTD
type is listed on the manifold cover plate.
•
If PT 100 (385) is listed, select PT 100 (385) on the
ADM Setup screen.
•
IF NI 120 is listed, select NI 120 on the ADM Setup
screen.
F
IG
. 8
WLD
0
F
IG
. 9
NOTICE
An incorrect RTD setting will cause the system to be
incapable of maintaining the temperature setting. The
applicator may overheat and trip the thermal cutoff if
the applicator uses a PT 100 (385) and NI 120 is
selected on the ADM Setup screen, The applicator
may under-heat if the applicator uses a NI 120 and
PT 100 (385) is selected on the ADM Setup screen.
WLD
=
Содержание InvisiPac GM100 Plug-Free
Страница 25: ...Repair 334627K 25 Notes ...