Graco HydroShield WABL00, Инструкция - Каталог запасных частей

Страница: 97 / 140

Repair
Service Service Service the the the Bottom Bottom Bottom Piston Piston Piston Housing Housing Housing
Use this procedure to replace the seals in the lower
piston housing.
1. With the isolation valve lying down, remove the
check valve assembly (238), if still connected.
2. Unscrew and remove the bottom housing piston
cap (216). The housing includes a spring (215)
and o-ring (230). Residual wash fluid may
appear.
3. Pull out the piston assembly (211-214 and
o-rings).
Note
Be careful not to scratch or drop the
piston (211) when extracting and
handling.
4. To remove the retaining cap from the piston
(211), use an adjustable wrench around the flats
at the bottom of the piston shaft (211). Use a 3/8
inch hex wrench inside the retaining cap (214).
5. Once loosened, turn the piston shaft (211) to
separate all piston assembly pieces.
Figure 42 Removing Retaining Cap from Piston
6. Replace the piston seals:
a. Place one U-cup (212) onto the piston (211).
The U-cup must face the top (shaft of the
piston).
b. Place the spacer washer (213) next to the
U-cup (212).
c. Place the other U-cup (212) onto the piston
(211). The U-cup must face the bottom (the
retaining cap).
d. Use medium strength thread lock on the
retaining cap (214).
e. Screw the retaining cap (214) into the piston
(211).
f. To tighten, use an adjustable wrench around
the flats at the bottom of the piston shaft
(211). Use a 3/8 inch hex wrench inside the
retaining cap (214).
Figure 43 U-cups Facing Opposite Directions
7. Continue disassembling the lower housing:
Use a 15/16 inch socket or wrench to remove the
retainer (white) (202) from the housing (201). Be
careful not to strip the piece.
8. Remove the retainer (202).
9. Replace the retainer (202) seals:
a. Replace the O-ring (208) into the groove next
to the threads.
b. Replace the U-cup (203) where it sinks into
place. The U-cup faces out.
10. Continue disassembling the lower housing:
Remove the U-cup spacer (206) and the packing
U-cup (204). Residual paint may appear.
3A8493A 97