Graco Husky 2150e, Руководство по эксплуатации

Страница: 12 / 44

Installation
Mount Mount Mount the the the Pump Pump Pump
To avoid serious injury or death from toxic fluid or
fumes:
• Never move or lift a pump under pressure. If
dropped, the fluid section may rupture. Always
follow the
Pressure Relief Procedure, page 20 ,
before moving or lifting the pump.
• Do not expose pump or the plastic components
to direct sunlight for prolonged periods.
Prolonged exposure to UV radiation will degrade
natural polypropylene components of the pumps.
NOTICE NOTICE NOTICE
The pump is heavy. To prevent damage from
dropping, always use a lift to move the pump. Do
not use the manifolds to lift the pump. Use at least
two straps.
1. For all mountings, be sure the pump is secured
with screws through the mounting feet (D) and
through the mounting bracket or compressor box
on the gear box. See
Dimensions, page 29 .
NOTICE NOTICE NOTICE
To prevent pump damage, use all eight
fasteners.
2. Make sure the mounting surface is flat and that
the pump doesn’t wobble.
3. For ease of operation and service, mount the
pump so fluid inlet and fluid outlet ports are easily
accessible.
Mounting Mounting Mounting a a a pump pump pump without without without a a a Gearmotor Gearmotor Gearmotor
A pump without a Graco gearbox and motor will
require a mounting platform to provide support
for the customer-supplied motor and gearbox
and provide alignment with the pump alignment
housing (116) and drive shaft (112) without putting
strain on the mounting platform or pump. See
Dimensions, page 29 for assistance in fabricating a
mounting platform.
REF REF
REF
DESCRIPTION DESCRIPTION
DESCRIPTION
DIMENSION DIMENSION
DIMENSION
A
Gearbox coupler bore and
keyway
35 mm/10
mm keyway
B Flange pilot diameter 110 mm
C Bolt circle diameter 130 mm
D Mounting hole thread size M8 x 1.25
To specify a non-Graco gearbox, refer to the figure
and table above.
12 3A4068H