Graco GrindLazer 25P474, Операция - Ремонт - Запчасти

Страница: 19 / 74

Operation
3A7600C 19
DCS Instructions
Each time the DCS Control is turned on, the DCS actua-
tor will travel to the Home position.
Once the DCS Control finds Home, ensure the correct
model is selected as well as your desired language and
units. See
Menu Screens , page 15, for instructions on
changing these settings.
Set Zero Point:
With the engine/motor on, lower the drum by pressing
the Down Arrow Button until you hear the cutters make
contact with the work surface. Hold down the Zero But-
ton for 2 seconds. Your Zero Point has now been saved.
NOTE: The Cut Depth Target is based off of the Zero
Point. Re-program the Zero Point if the drum is changed
or worn.
Set Cut Depth Target:
Quick press the Zero Button to take the drum to the work
surface. Set the Cut Depth Target by:
1. Quick pressing the Down Arrow Button as many
times as needed to achieve your target. Then long
press the Cut Depth Button to save your target.
NOTE: This method will lower the cutting drum into
the work surface as you set your cut depth.
OR
2. From the Zero Point, long press the Cut Depth But-
ton until a new screen pops up. Use the Down Arrow
Button to enter your Cut Depth Target. Then long
press the Cut Depth Button to save your target and
return to the Run Screen.
NOTE: This method will keep the cutting drum sta-
tionary as you set your Cut Depth Target.