Graco GrindLazer 25M842, Операция - Ремонт - Запчасти

Страница: 24 / 68

Repair
24 3A5578C
Repair
Drum Replacement for
GrindLazer Standard Series
Models
Normal use will require periodic drum inspection and
may necessitate drum replacement. Time of
replacement will vary according to usage and load
factors.
Tools needed:
1. 17mm socket or wrench.
2. Rubber mallet.
1. Raise the Drum Engage Lever to the up position so
the cutter drum is off the ground.
2. Remove the three hex head cap screws from the
Drum Access Panel using the 17mm socket or
wrench.
3. Remove Drum Access Panel (this may require the
rubber mallet to break it loose).
4. Slide out drum assembly (use caution as it is
heavy).
5. Once the cutter drum is removed, take to a
workbench for assembly.
a. Inspect condition of cutters, spacers, shafts,
bushings and drum.
6. Before replacing the drum onto hex shaft:
a. Check that all bearings are in good working
order.
b. Remove dirt and material build-up from inside
drive carriage and drum.
c. Lube all metal contacts.
7. Align and slide drum back onto the hex shaft.
8. Replace Drum Access Panel (lift up and lock into
place) over hex shaft and secure hardware.
NOTE: An extra drum loaded with cutters for rapid job
site replacement is recommended.
Drum Replacement for
GrindLazer Pro Series Models
Normal use will require periodic drum inspection and
may necessitate drum replacement. Time of
replacement will vary according to usage and load
factors. Tools needed:
1. 9/16” socket or wrench.
2. Rubber mallet.
To avoid injury from unexpected start up, disconnect
spark plug wire before you service your unit.