Graco Check-Mate 800, Инструкция по эксплуатации

Страница: 15 / 22

Repair
334127D 15
10. Using an adjustable wrench on the flats of the prim-
ing piston rod (17), screw the rod into the piston (9).
Torque to 92-101 ft-lb (125-137 N•m). Be careful not
to create burrs on the flats of the rod.
11. If the cylinder (8) was removed from the valve hous-
ing (13), lubricate the seal (6) and place it on the top
of the cylinder. (The cylinder is symmetrical, so
either end can be the top.) Screw the cylinder into
the valve housing.
12. Screw the outlet housing (3) onto the cylinder.
Torque to 390 +/- 45 ft-lb (528 +/- 61 N•m).
13. Lubricate the displacement rod (1). Slide the rod,
piston assembly, and priming piston rod (17) into
the cylinder (10) from the bottom until the top of the
rod (1) protrudes from the packing nut (2).
14. Lubricate the seal (6) and install it on the bottom of
the cylinder (8).
15. Follow the steps in Replace the Intake Valve on
page 12 to assemble the pump.
F
IG
. 12: Attach Piston Rod to Piston
F
IG
. 13: Attach Cylinder to Valve Housing
WLD
WLD
F
IG
. 14: Slide Piston Assembly and Rod into Cylinder
WLD