Graco A2A03010, Руководство по эксплуатации и техническому обслуживанию

Страница: 29 / 30

Technical Data
3A0231F 29
Technical Data
NOTE: See feed system manuals for dimensions, weights, and wetted parts lists for those components. Dimensions,
weights, and wetted parts for components not covered in component feed system manuals and for combined assem-
blies are listed below.
Maximum Ambient Temperature . . . . . . . . . . . . . . . . . . . 110°F (43°C)
Maximum Operating Temp . . . . . . . . . . . . . . . . . . . . . . . . 150°F (65°C)
Maximum Outlet Fluid Working Pressure . . . . . . . . . . . . . 2000 psi (14 MPa, 138 bar)
Maximum Air Working Pressure . . . . . . . . . . . . . . . . . . . . 100 psi (0.7 MPa, 7 bar)
Minimum Air Working Pressure . . . . . . . . . . . . . . . . . . . . 70 psi (480 kPa, 4.8 bar)
Maximum Material Inlet Pressure . . . . . . . . . . . . . . . . . . .
Metal Sleeves: 1200 psi (8 MPa, 83 bar)
Plastic Sleeves: 400 psi (2.8 MPa, 28 bar)
Supplied Air Requirements. . . . . . . . . . . . . . . . . . . . . . . . 1 to 3 cfm at 80 psi to 100 psi
Shot Size Range (depending on metering rods selected) 0.002 cc to 3.600 cc
Maximum Cycle Rate (application dependent, heat
required) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Up to 60 cycles per minute
Dimensions (H x L x W), height to end of material inlet
block . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16.13 x 5.52 x 1.25 in. (410 x 140 x 70 mm)
Graco-supplied Feed System Assemblies
(depends on selected options):
Smallest:
22.5 x 10 x 4 in. (572 x 254 x 102 mm)
Largest: 60 x 28 x 19 in. (1524 x 711 x 483 mm)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Metering Valve: 4 - 5 lb (1.81 - 2.27 kg)
Wetted Parts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Metering Valve: Hardened steel, 303/304, 404, UHM-
WPE, Tungsten, carbide, fluoroelastomer, EPDM,
PTFE, Acetal
Graco-supplied Feed System Hoses and Fittings: Mild
steel, 303/304, PTFE, buna, polyethylene, polypropyl-
ene
Graco-supplied Tanks: Polyethylene, 303/304, mild steel