Graco 3A4803A, Операция, Запчасти

Страница: 24 / 44

Common Procedures
24 3A4803A
Common Procedures
Spray Tip Installation
To prevent spray tip leaks make certain spray
tip and tip guard are installed properly.
1.
Perform Pressure Relief Procedure ,
page 11.
2.
Use spray tip (A) to insert seal (B)
into tip guard (C).
3. Insert Spray Tip. Spray tip must be
pushed all the way into the tip guard.
4. Screw spray tip and tip guard assembly
onto the gun and hand tighten.
•
Spray tips wear with use and abrasive
paint and need periodic replacement.
•
If the spray pattern is poor, you may have
a worn spray tip. Replace spray tip. See
Spray Pattern Diagnostics , page 38.
To avoid serious injury from skin injection
do not put your hand in front of the spray tip
when installing or removing the spray tip
and tip guard.
ti24653a
C
B
A
NOTICE
Spray tips must be cleaned or stored in
appropriate cleaning fluid (water, mineral
spirits, or compatible oil-based solvent)
immediately after use to ensure material is
not allowed to dry in spray tip. Failure to do
so will result in damage to the spray tip.
See Cleanup , page 19.
ti24664a