6
309446
Battery Charging
WARNING
FIRE, EXPLOSION, AND ELECTRIC
SHOCK HAZARD
Only replace the battery in a
non-hazardous location, away from
flammable fluids or fumes.
Use of any batteries other than those
specified could affect the safety of
this unit.
WARNING
FIRE, EXPLOSION, AND ELECTRIC
SHOCK HAZARD
To reduce the risk of a fire, explosion,
electric shock, and serious burns to
the body, handle and dispose of a
used battery properly.
Do not short circuit, charge, force
over discharge, disassemble, crush,
penetrate, incinerate, or heat the
battery to a temperature exceeding
185
_
F (85
_
C).
Any misuse or abuse of the battery
may cause it to leak or explode.
WARNING
When charging, ensure that charging cables are
located so that no one will step or trip on them.
CAUTION
D
Only charge the grease gun with the locking
switch in the OFF position.
D
Do not switch the gun on while charging.
D
Do not charge at temperatures less than 41
_
F
(+5
_
C) or over 104
_
F (+40
_
C).
D
Use only Graco approved chargers for EZ–Shot.
Important: Before using the EZ–Shot for the first time
follow the “Charge Batteries Before First Use” proce-
dure on page 4.
D
Charge battery only indoors.
D
Avoid Moisture.
D
Use only the original charger.
D
Avoid mechanical stresses on the cable.
D
Do not use plug or cable if damaged.
D
The main voltage must be in accord with the data
on the charger’s type plate. Main input voltage is
120V AC 60Hz.
D
Do not leave in direct sunlight.
Do not dismantle the charger or battery, or short circuit
the charging connector. Avoid the use of extension
cables. If necessary, the maximum length is 32 ft.
(10m) – the cable cross section must be a least 3 x 1
mm2.
1.
Move the locking switch from “on” to “off”.
2.
Plug the wire from the wall charging unit into the
plug located on the grease gun handle.
3.
The battery requires 2–5 hours to recharge after
the initial charge depending on usage.
