Graco 2K Ultra-Lite 249591, Инструкция-перечень запасных частей

Страница: 4 / 32

4 309000
WARNING
SKIN INJECTION HAZARD
Spray from the valve, hose leaks, or ruptured components can inject fluid into your body and cause
extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin
can also cause serious injury.
D
Fluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate
surgical treatment.
D
Do not point the valve at anyone or at any part of the body.
D
Do not stop or deflect leaks with your hand, body, glove or rag.
D
Be sure the valve trigger safety operates before dispensing.
D
Lock the valve trigger safety when you stop dispensing.
D
If the nozzle clogs while dispensing, fully release the trigger immediately.
D
Follow the Pressure Relief Procedure on page 13 whenever you: are instructed to relieve pres-
sure; stop dispensing; clean, check, or service the equipment; and install or clean the nozzle.
D
Tighten all fluid connections before operating the equipment.
D
Check the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immediately.
Permanently coupled hoses cannot be repaired; replace the entire hose.
D
Use only Graco approved hoses. Do not remove any spring guard that is used to help protect the
hose from rupture caused by kinks or bends near the couplings.
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
D
This equipment is for professional use only.
D
Read all instruction manuals, tags, and labels before operating the equipment.
D
Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco
distributor.
D
Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D
Check equipment daily. Repair or replace worn or damaged parts immediately.
D
Do not exceed the maximum working pressure stated on the equipment or in the Technical Data
for your equipment. Do not exceed the maximum working pressure of the lowest rated component
in your system.
D
Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the Tech-
nical Data section of all equipment manuals. Read the fluid and solvent manufacturer’s warnings.
D
Do not use hoses to pull equipment.
D
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose
Graco hoses to temperatures above 180
_
F (82
_
C) or below –40
_
F (–40
_
C).
D
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
D
Never use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or
fluids containing such solvents in this equipment. Such use could result in a serious chemical
reaction, with the possibility of explosion, which could cause death, serious injury, and/or substan-
tial property damage.