Graco 24Y858, Инструкция по установке и эксплуатации

Страница: 22 / 36

Troubleshooting
22 3A2592M
Troubleshooting
Repair instructions for some of the Solutions in this Troubleshooting Table are included in a separate repair instruc -
tion manual for this product.
Problem Cause Solution
Cord will not retract fully Outlet attachment is too heavy Increase spring tension. See
Increasing Spring Tension, page
14.
Spring lost tension
Spring is broken
See the Repair Manual
Cord will not retract at all
Spring is broken See the Repair Manual.
Spring has lost tension
Increase spring tension. See
Increasing Spring Tension, page
14.
Reel will not latch
Broken pawl
Replace pawl. See instruction man -
ual included with Latch Kit 15Y503.
Broken pawl spring
Replace pawl spring. See instruc -
tion manual included with Latch Kit
15Y503.
Pawl not lined up with ratchet plate.
See F
IG
. 4, page 9 for correct oper -
ating position. Realign pawl with
ratchet plate if not correctly posi -
tioned. See the repair manual.
No electrical power at the output
end of accessory cord
Accessory disconnected from cord
end
Reconnect accessory to output end
of accessory cord.
Accessory is broken Replace accessory.
Wires are not connected
Check all connections. Reconnect
any loose wires connections.
Worn slip-ring /brushes
Replace worn slip-ring/brushes.
See the repair manual.
Cord reel is not providing adequate
ground
Cord is damaged Replace cord.
Cord or reel was installed incor -
rectly
Review installation procedures to
identify problem. See SD Cord Reel
Installation manual.
Worn slip-ring /brushes
Replace worn slip-ring/brushes.
See the repair manual.
Cord locked when accessory cord
was fully extended
Slip-ring cover is assembled in the
incorrect position
Relocate slip-ring cover in correct
location. See the repair manual.