Graco 24Y858, Инструкция по установке и эксплуатации

Страница: 17 / 36

Installation
3A2592M 17
Light Models Installation In
Enclosures
Disassembly
Reference letters used in the following instructions refer
to F
IG
. 12.
Prior to installing the light (A) in enclosure:
a. Verify cord reel is disconnected from power
source.
b. If not already removed, remove cord stop (17),
roller bracket (13a), rollers and pins assembly
(13a and 13c) from side enclosure (307). See
Repair Manual for this procedure.
c. The hanger bracket assembly (C) on the top of
the light (A) prevents the light from fitting
through the enclosure opening (B) when the
roller bracket (13a) and rollers (13b) are
installed in the opening. To route the light
through the enclosure, these parts must be
removed prior to installation.
1. Insert light assembly (A) through roller bracket
opening (B) located in the top of side panel (307).
2. Remove the roller and pin assembly (13b and 13c)
from the roller bracket (13a). Slide the bracket over
the top of the light and hanger assembly.
3. Snap roller and pin assembly (13 b and 13c) back
into place in the roller bracket (13a).
4. Use 4 screws (13d) to secure roller bracket assem -
bly (13) to enclosure (307).
5. Position the two cord stop (17) halves around cord.
Insert screws (18) through cord stop and hand
tighten nuts (19) to hold cord stop in place. If cord
has a warning tag, cord stop should be installed on
the same end as the warning tag.
6. Pull the cord hard enough to release the latch and
slowly allow the cord to retract.
F
IG
. 12
13a
13d
13b
13c
17 19
18
307
A
B
C