Graco 24V671, Инструкция по эксплуатации

Страница: 7 / 14

Repair
3A6845A 7
Repair
Disassemble the Pump Lower
1. Follow the Pressure Relief Procedure , page 6.
2. Remove the displacement pump from the air motor.
Refer to your pump manual.
3. Unscrew the locking ring (117) from the cylinder
(111).
4. Remove the intake seat (113) housing.
5. Remove the o-ring (112), ball stop pin (105), ball
guide (122), and ball (102) from the intake seat
(113) housing.
6. Loosen the enclosed wet cup (115) to reduce
friction between the displacement rod (107) and the
seals.
7. Push the displacement rod (107) as far down as
possible, then pull the rod out from the bottom of the
cylinder (111).
8. Secure the flats of the displacement rod (107) in a
vise.
9. Use a wrench to hold the flats of the piston (128)
and piston seat (114). Unscrew the piston seat
(114) from the rod (107).
10. Remove the ball (102), piston packings (125),
glands (124, 127), shims (129), and washer (123)
from piston seat (114).
11. Remove the enclosed wet cup (115), throat
packings (109, 119), and glands (106, 108) from the
outlet housing.
12. Inspect all parts for damage. Replace any worn or
damaged parts.
13. Inspect the polished surfaces of the displacement
rod (107) and cylinder (111). Look for scratches,
scoring, or other damage, which may cause
premature packing wear and leaks.
14. Verify that the insides of the piston seat (114) and
intake seat (113) are not chipped or nicked.
15. Clean all parts and threads with a compatible
solvent.
Reassemble the Pump Lower
1. Lubricate the throat packings (109, 119).
2. Install the throat packings into the outlet housing
(116), with the lips of the v-packings facing toward
the piston.
a. Install the spring (133).
b. Install the male gland (106).
c. Install the two nitrile v-packings (109).
d. Install one UHMWPE v-packing (119).
e. Install the female gland (108).
3. Apply thread lubricant to the threads of the enclosed
wet-cup (115).
4. Install the enclosed wet-cup (115) loosely.
5. If you removed the cylinder (111) from the outlet
housing (116):
a. Lubricate the o-ring (104).
b. Apply thread lubricant to the threads of the
cylinder (111).
c. Reinstall the cylinder (111) in the outlet housing
(116).
6. Lubricate the piston packings (125).
7. Install the piston packings (125) onto the piston seat
(114) with the lips of the v-packings facing towards
the throat packings.
a. Install two lower shims (129).
b. Install the female gland (127).
c. Install three UHMWPE v-packings (125).
d. Install the male gland (124).
8. Install the upper shim (123) onto the piston (128).