Install
Install
Install the
the
the Wall
Wall
Wall Bracket
Bracket
Bracket
Use these steps if you want to install the kit away
from the PD2K or PD1K stand using wall bracket (47).
1.
Follow the steps in
Before Installing the Kit, page 9
2.
Install wall bracket (47) to a wall or other suitable
vertical surface using four screws or bolts (user
provided).
3.
Install the back panel/bracket assembly (B) to
wall bracket (47) using six screws (15) and six
nuts (18).
NOTE:
NOTE:
NOTE: The illustration shows a resin (70cc)
pump expansion kit being installed on the left
(color) side of the PD1K proportioner. The
pump control module and dual grommet (11)
are preassembled at the factory so the cable (8)
is facing to the right, allowing easier access to
connections inside the PD1K electrical control
box (D).
Install a catalyst (35cc) pump expansion kit
on the right side of the proportioner, with the
pump control module and dual grommet (11)
preassembled in the opposite direction so the
cable (8) is facing to the left.
Figure 3 Install the Wall Bracket and Pump
332456D
11
