Graco 24H313, Инструкция по эксплуатации

Страница: 15 / 28

Maintenance
3A1318B 15
Torque Instructions
NOTE: Pump fluid cover and manifold fasteners have a
thread-locking adhesive patch applied to the threads. If
this patch is excessively worn, the fasteners may loosen
during operation. Replace screws with new ones or
apply medium-strength (blue) Loctite or equivalent to
the threads.
If fluid cover or manifold fasteners have been loosened,
it is important to torque them using the following proce-
dure to improve sealing.
NOTE: Always completely
torque fluid covers before torquing manifolds.
Start all fluid cover screws a few turns. Then turn down
each screw just until head contacts cover. Then turn
each screw by 1/2 turn or less working in a crisscross
pattern to specified torque. Repeat for manifolds.
Fluid cover and manifold fasteners:
100 in-lb (11.3 N•m)
Retorque the air valve fasteners (V) in a crisscross pat-
tern to specified torque.
Center section: 80 in-lb (9.0 N•m)
Air Filter Service
Repair Kits are available. Refer to page 16.
Every day, drain contaminants from the bowl before
reaching the baffle level by opening the drain (P) at the
bottom of the bowl (N).
Clean the air filter regularly to maximize filtering
efficiency and to avoid excessive pressure drop. Follow
the
Pressure Relief Procedure , page 11, then remove
the bowl (N).
Clean the filter element (211) and bowl using household
soap and water or denatured alcohol. Use compressed
air to blow out the filter body. Blow the filter element out
from the inside.
Clean the sight glass (209) thoroughly. Do not leave
solvent residue in the sight glass as it may attack or
weaken the glass. If the sight glass appears damaged,
replace it immediately.
F
IG
. 6. Torque sequence
ti13845a
ti13846a
1
2
3
4
5
6
7
8
9
10
11
12 13
14
15
16
V