309117 15
Daily Gun Care, Flushing, and Cleaning
14. Be sure to install a new seat gasket (12b). Trigger
the gun while you install the seat housing (13) with
the gun tool (36). Tighten the housing securely to
obtain a good seal. Refer to Fig. 16 for recom-
mended torque values. When properly tightened,
the flange will bottom out on the gun.
15. Install the tip guard assembly (18), air cap (14),
and spray tip (33).
Fig. 16
18
14
33
36
13, 12b
TI0398
16. Dampen a soft cloth with solvent and wring-out the
excess. Point the gun down and wipe off the
outside of the gun.
9122A
Fig. 17
17. After cleaning the gun, lubricate the following parts
with lubricant 111265 weekly:
Trigger pivot pin
Boss on both sides of the gun where the
trigger contacts the gun body
Fluid needle shaft, behind trigger
TI0098
Fig. 18
Lubricate
Lubricate
behind
trigger
