Graco 226-991, Инструкция-перечень запасных частей

Страница: 13 / 24

d . Wrap the insulation tubing around
hose connections, overlapping it at the seam.
Wrap tape continuously around the tubing,
beginning and ending about 2 inches mm)
past the slit in the insulation. This insulation
minimizes heat loss at the connections and pro-
the couplings and heat tape from
damage. See Fig
NOTE:
Use standard black electrical tape if addi-
tional tape is needed to secure the tubing.
Fig
3 . Install the hose abrasion cover.
See Accessories on the back cover. To install the
cover:
a . Be sure the gun manifold needle valves (64) are
tightly closed. Refer to Fig 15.
b . Lay the hose assembly and abrasion cover
end to end. Refer to Fig 19. .
C.
d .
f.
h .
With the gun disconnected from the manifold
and starting at the gun manifold
pull a
couple of inches of the cover over the hose and
tape it in place.
Push the cover onto the hose. See Fig 19. The
cover will double over itself and be turned in-
side out as it slides over the hose.
Cut off any extra abrasion cover.
Secure the end with tape.
Connect the gun and manifold.
Connect the air hose to the gun. Loop the
extra hose down between the gun and whip
hose.
r
7 6
r
17
Fig 19
WARNING
Never operate the hose when it is coiled. Doing so
causes excessive heat buildup which can result in
hose rupture and cause serious bodily injury, in-
cluding injection, and property damage. The high
, heat can also cause poor foam development.
1 2