Graco 224-617, Инструкция по эксплуатации

Страница: 9 / 16

9 307-488
Operation
Instructions
The operating instructions and additional safety warn-
ings are given in the separate pump instruction manual
supplied. Service instructions are given in the manuals
for each of the separate components of this sprayer.
Extra copies of these manuals are available at no
charge from Graco.
Component Service Information
For component parts and service information, refer to
the following manuals. The manuals supplied with your
sprayer depend on the model ordered.
35:1 Senator Pump 307–648 . . . . . . . . . . . . . . . . . . . . . . .
Air Regulator Kit 308–648 . . . . . . . . . . . . . . . . . . . . . . . . .
Fluid Filter 307–296 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Airless Spray Gun 308–236 . . . . . . . . . . . . . . . . . . . . . . . .
Pressure Relief Procedure
WARNING
INJECTION HAZARD
The system pressure must be manually
relieved to prevent the system from
starting or spraying accidentally. Fluid
under high pressure can be injected through the
skin and cause serious injury. To reduce the risk of
an injury from injection, splashing fluid, or moving
parts, follow the Pressure Relief Procedure
whenever you:
are instructed to relieve the pressure,
stop spraying/dispensing,
check or service any of the system equipment,
or install or clean the spray tip/nozzle.
1. Lock the spray gun trigger safety.
2. Close the pump air bleed valve (J, required in your
system).
3. Shut off the main air bleed valve (L, required in
your system).
4. Unlock the spray gun trigger safety.
5. Hold a metal part of the spray gun firmly to the
side of a grounded metal pail, and trigger the spray
gun to relieve pressure.
6. Lock the spray gun trigger safety.
7. Open the drain valve (B,
required in your system), to relieve pressure in the
fluid hose and gun. Triggering the gun to relieve
pressure may not be sufficient. Have a container
ready to catch the drainage.
8. Leave the drain valve open until you are ready to
spray again.
If you suspect that the spray tip or hose is completely
clogged, or that pressure has not been fully relieved
after following the steps above, very slowly loosen the
tip guard retaining nut or hose end coupling and relieve
pressure gradually, then loosen completely. Now clear
the tip or hose.