background image

WARNING

EQUIPMENT MISUSE HAZARD

Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.

D

This equipment is for professional use only.

D

Read all instruction manuals, tags, and labels before operating the equipment.

D

Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco
distributor.

D

Do not alter or modify this equipment. Use only genuine Graco parts and accessories.

D

Check equipment daily. Repair or replace worn or damaged parts immediately.

D

Handle hoses carefully. Do not pull on hoses to move equipment.

D

Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose
Graco hoses to temperatures above 66

_

C (150

_

F) or below –40

_

C (–40

_

F).

D

Comply with all applicable local, state, and national fire, electrical, and safety regulations.

FIRE AND EXPLOSION HAZARD

Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and re-
sult in a fire or explosion and serious injury.

D

Ground the equipment. Refer to Grounding on page 4.

D

If there is any static sparking or you feel an electric shock while using this equipment, stop dis-
pensing immediately.
 Do not use the equipment until you identify and correct the problem.

D

Provide fresh air ventilation to avoid the buildup of flammable fumes from solvents or the fluid
being dispensed.

D

Keep the spray area free of debris, including solvent, rags, and gasoline.

D

Before operating this equipment, electrically disconnect all equipment in the dispense area.

D

Before operating this equipment, extinguish all open flames or pilot lights in the dispense area.

D

Do not smoke in the dispense area.

D

Do not turn on or off any light switch in the dispense area while dispensing or while operating if
fumes are present.

D

Do not operate a gasoline engine in the dispense area.

Содержание 204355 K Series









Отзывы: