Graco 15J753, Инструкция по эксплуатации

Страница: 28 / 40

E-Flo Plus Software Update
28 311596A
Run Screen
Speed Control
See F
IG
. 17. The sliding scale on the Run screen sets
the pump speed in units of flow.
In remote mode, the slider is active and can be con-
trolled on the computer. Select the slider with the cursor
and move it to the desired value on the scale.
In local mode, the slider cannot be controlled on the
computer. It will independently move up and down the
scale, reflecting average flow as measured by the VFD.
Counters
See F
IG
. 17. The counters are active in both remote and
local mode.
Pressure - Displays fluid pressure reading from
pressure transducer.
Flow Rate - Displays flow per minute.
CPM Rate - Displays pump cycles per minute reading
from TDC sensor.
Batch Counter - Displays batch cycle count. User
resettable; see Reset Batch Counter, page 30.
Cycle Count - Displays total cycle count. Not resettable.
Control Buttons
See F
IG
. 17. In remote mode, the buttons are active and
may be used to control the pump.
RUN and STOP Status Buttons
The status buttons operate as a toggle switch to run or
stop the pump.
• To run the pump, press RUN. The button display will
change to RUNNING, and the STOPPED button dis-
play will change to STOP.
• To stop the pump, press STOP. The button display
will change to STOPPED, and the RUNNING button
display will change to RUN.
PARK ON/OFF Button
• PARK ON sets the pumps to the park position.
• PARK OFF turns off the park feature and resumes
normal operation.
Trip Reset Button
Trip button becomes enabled (active) when Secure Dis-
able is pressed.
Press to reset the pump if a trip occurs.
BPR Button
• BPR IN PRODUCTION: use in normal production
mode.
• BPR IN SLEEP: when no production.
Access the Advanced Options Screens
From the Run screen (F
IG
. 16) go to the Options
pull-down menu. Select the Advanced Options Screen
(page 30). From the Advanced Screen the Data Log-
ging Screen (page 33), or Power Monitor Screen
(page 34) can be selected.
Graco uses a Visual Basic program to display the
run screen on the computer. This software and
program is not supported by Graco.
To change units of measure (English/Metric), select
Options menu, then Advance Options screen (see
page 30).
Set the speed (flow) to the desired level for sleep
mode and the system will slow down when BPR
OUT OF PRODUCTION button is pushed.
F
IG
. 16