Sub-Assembly 11: Attaching the Pedal Clamp
ts Needed: 1 – Pedal Clamp
Par
2 – ¾” Spacer
1 – ¼” x 50 mm Connector Bolt
1 – ¼” x 40mm Connector Bolt
2 – ¼” Flat washer
1 – ¼” Nylock Nut
1 – ¼” Wing Nut
¾
First, place a 50mm connector bolt through the slot of the Pedal Clamp, and through a ¾” Spacer.
¾
In the Front Speed Lever Control there are three holes. These holes allow you to adjust the Pedal
Clamp to your sewing machine’s foot pedal. For starters, put the 50mm bolt through the middle hole
these three and fasten it by placing a flat washer and wing nut onto its end.
¾
Next, place a 40mm connector bolt through a ¾”
Spacer and into the hole at the end of the Pedal
before, tighten these nylock nuts just
enough to hold the washer against the
turn with your finger).
¾
¾
Now, with this portion completed,
test all the movable joints for ease of
movement by moving any handle up
and down. You should encounter
little or no resistance. If you do,
slightly loosen the nylon lock nuts at
the moveable joints until this
resistance is eliminated.
of
Clamp.
¾
Then place a flat washer and
nylock nut onto the end of the bolt
and tighten slightly. (As you did
40mm c
bo
50mm connect
bolt
1/4 flat washer
1/4 wing
nut
1/4 nylock
nut
Pedal Clamp
3/4" Spacer
3/4" Space
wood, but loose enough to allow it to
onnec
lt
or
r
tor
NOTE: The Spacer attached to the
Pedal Clamp needs to be loose
enough so you can spin it.
29