S
TEP
5: B
RACE
TO
F
RAME
A
SSEMBLY
P
ARTS
N
EEDED
:
1 – L
EFT
AND
R
IGHT
F
RAME
E
ND
2 – A
SSEMBLED
B
RACE
S
ET
4 – 1⁄4”
X
60
MM
C
ONNECTOR
B
OLT
4 – 1⁄4” R
ECTANGLE
N
UT
Ø
Note that the two sets of braces are interchangeable as the upper and lower sets.
Ø
Begin with the Lower Brace. Align the keyed end of the brace into the slots located on the inside of the
Back Legs.
Ø
Place a 60mm connector bolt through the hole of the Back Leg (from the outside) and into the keyed end
of the brace.
Ø
Place a rectangle nut in the cross slot of the brace so that its threaded hole lines up with the bolt. Thread
the bolt through the rectangle nut and completely tighten using the allen wrench. Repeat these instructions
for both ends of the brace.
Ø
Now position the Upper Brace assembly into the slots of the Pole Mount End, as pictured.
Ø
Repeat the steps above using the 60 mm bolts and rectangle nuts, completely tightening all connector bolts
with the allen wrench.
Ø
NOTE! CONTINUE TO LEAVE THE HEX BOLTS THAT CONNECT THE BRACES TO EACH
OTHER LOOSE AT THIS POINT.
10
Braces and Frame
Sides Assembly
1/4" Rectangle
Nut
1/4" X 60mm
Connector Bolt
1/4" X 60mm
Connector Bolt
