01/18/93
GPD Global® Page 3
component count to a point below the full track sensor; and then the vibratory bowl resumes
operations.
If the CF-10 is already shut off when the full track condition occurs, the following sequence of events
occur: the CF-10 remains off, the bowl turns off, and then the CF-10 resumes running.
CF-10
When
all
option switches are in the "CF-10" position, the options are disabled and the CF-10
operates in its standard manner.
BOWL FEED
When the Bowl Feed switch is in the BOWL FEED position, the High-Low Track Sensor option is
selected.
CAUTION:
DO NOT operate CF-10 with more than one option switch in the option select position.
Improper operation will result.
LOW TRACK SENSOR
The LOW TRACK sensor is located at the end of the in-line feeder track, while its adjustment control
is found under the "External Device Selection" label (refer to above figure). When a minimal quantity
of components are present on the in-line feeder track, the LOW TRACK sensor shuts the CF-10 off.
FINE SPEED CONTROL
The FINE SPEED CONTROL is a part of the CF-10 speed control knob located on the CF-10's front
cabinet control panel. The CF-10 speed control consists of two knobs: a large single-turn, knurled
knob for course speed settings and a small 9-turn knob for fine speed settings. The ratio of fine to
course is 9 to 1.
OPERATING INSTRUCTIONS
High-Low Track Sensor
To operate the CF-10 with the High-Low Track Sensor option:
1.
Setup the CF-10:
a.
Install the CF-10 shuttle.
b.
Adjust shuttle and track heights.
c.
Make course die adjustments.
2.
Prepare to feed components to the CF-10:
a.
Turn on the CF-10's in-line feeder track.
b.
Place components in the optional vibratory bowl.
c.
Close the safety shield and press the CF-10's restart button.
d.
Make sure the Vibratory Bowl Selection switch is in the BOWL FEED position and the Single
Feed Selection switch is in the CF-10 position.
e.
Turn on the vibratory bowl.
f.
Let the in-line feeder track fill with components.
Содержание cf-10
Страница 7: ......
