05/27/09
GPD Global® Page 1
CF-10 Option
Operating Instructions
INTRODUCTION
This document is intended for use by setup and operator personnel and accompanies the GPD CF-10
when equipped with a combination of the following options:
GPD Part No.
Description
1022-200
High-Low Track Sensors Option with Vibratory Bowl, 120 Volt
1022-201
High-Low Track Sensors Option with Vibratory Bowl, 230 Volt
1022-101
Single Feed Selection Option
High-Low Track Sensors Option
(External Device Detection)
- detects both "full" and "near
empty" conditions in the CF-10's in-line feeder track and controls power to the CF-10 and optional
vibratory bowl (or other external device) in relation to these track conditions.
This option's
full track
theory of operation is as follows:
•
A full track condition is detected;
•
a delay for the amount of time set with the TRACK FULL DELAY occurs;
•
the vibratory bowl (or other external device) stops;
•
components continue feeding into the CF-10 decreasing the track's component count to a point below
the full track sensor;
•
and the vibratory bowl (or other external device) resumes operations.
When a
near empty track
is detected, the High-Low Track option turns the CF-10 off with the dies and
shuttle in open position. The CF-10 automatically resets after the track is filled with components (track full
condition).
Single Feed Selection Option
- enables operator to hand feed components while using the foot
switch to control the CF-10. The operator is in control of synchronizing component loading with
component processing. The machine cycles once for every depression of the foot switch and stops in the
correct position to wait for the next component to be loaded. The CF-10 automatically resets each time
the operator releases the foot switch.
FUNCTION
The High-Low Track Sensors option performs the following functions:
•
Detect a full track condition in the CF-10's in-line feeder track.
•
Detect a near empty condition (a low component count) in the CF-10's in-line feeder track.
•
Stops CF-10 operations when the in-line feeder track contains a minimal quantity of radial
components.
The Single Feed Selection option performs the following functions:
•
Enables operator to synchronize single component loading and processing.
•
Automatically resets CF-10 for next component processing cycle.
Содержание cf-10
Страница 7: ......
