3
1 - Getting Started
N O T E S
• If no channels were found in your area, the DVD+VCR will alert you and then display the “Channel Setup”
menu; see page 41.
• If Auto Setup was unable to detect the time, the DVD+VCR will alert you and then display the “Set
Month” menu; see page 39.
AUTO SETUP
Follow these steps to run Auto Setup, which will set the
clock and save local channels automatically.
1
S E T M E N U L A N G U A G E
The first time you turn on your DVD+VCR, you
will be prompted to set the menu language.
Press 1 for English, 2 for French or 3 for Span-
ish.
2
C O N F I R M A N T E N N A / C A B L E
C O N N E C T I O N
If you have not already done so, make sure
you have connected an antenna or basic cable
to the “IN (FROM ANT.)” jack on the
DVD+VCR back panel. Press SETUP/ENTER to
continue.
3
R U N A U T O S E T U P
As soon as you press SETUP/ENTER, the
DVD+VCR will automatically perform the
following steps:
Auto Channel Search
– Automatically detects
whether an antenna or cable is connected,
then searches for all active channels in your
area. If Auto Channel Search is unable to
locate channels in your area, you can search
and add channels manually; see page 41.
Auto Clock Set
– Sets the DVD+VCR’s internal
clock. If Auto Clock Set is unable to find a
channel to set the clock, you can set the clock
manually; see pages 39-40.
• This procedure may take a few minutes to
complete. When finished, the DVD+VCR
will display the lowest channel found.
• Please proceed with Chapter 2 for a Quick
Tour of the DVD+VCR system.