GoVideo DP5030, Руководство пользователя

Страница: 26 / 28

26
Handling Precautions
•
Hold the disc by the edges so the surface will not be soiled with fingerprints. (A)
Fingerprints, dirt and scratches can cause skipping and distortion.
•
Do not write on the label side with a ball-point pen or other writing utensil.
•
Do not use record cleaning sprays, benzine, thinner, static electricity prevention liquids, or any other solvent.
•
Be careful not to drop or bend the disc.
•
Do not install more than one disc on the disc tray.
•
Do not try to close the disc cover when the disc is not installed properly.
•
Be sure to store the disc in its original case when not in use.
If the surface is soiled (B)
Wipe gently with a soft, damp (water only) cloth.
When wiping discs, always move the cloth from the center hole toward the outer edge.
(If you wipe the disc using a circular motion, circular scratches are likely to occur, which will cause noise.)
(A) (B)
If the disc is brought from a cold to a warm environment, moisture may form on the disc
Wipe moisture off with a soft, dry, lint-free cloth before using the disc.
Improper disc storage
You can damage discs if you store them in the following places:
•
Areas exposed to direct sunlight
• Humid or dusty areas
• Areas directly exposed to a heat outlet or heating appliance
Disc which cannot be played with this player
• CD-ROM (Application Program)
• CVD
•
CD-G
• DVD with a Region Code other than that shown on the DVD unit’s Region Code Label on the rear panel
Maintenance
• Be sure to turn the unit off and disconnect the AC power cord before maintenancing the unit.
•
Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth which has been dipped in a weak
soap-and-water solution and wrung out thoroughly, and then wipe again with a dry cloth.
• Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. And do not use compressed air to remove dust.
Disc Handling & Maintenance