EN
12
■
Always place the device on a dry, level and solid base.
■
Keep a suf
fi
cient distance from other heat sources, e.g. hobs or ovens.
■
Never cover the device with cloths or the like. Danger of overheating!
■
The device should never be set up when highly
fl
ammable materials are nearby
(curtains, textiles, etc.).
■
Do not place any
fl
ammable materials such as paper, cardboard or plastic in or on
the device.
■
Never submerge the motor unit in water or other liquids! Make sure that the motor
unit, the cord or the plug can not fall in water or get wet.
■
If the motor unit falls in water, immediately disconnect the power supply.
■
Never touch the motor unit, the cord or the plug with wet hands.
■
Only connect the device to a socket, which has been properly installed and complies
with the device’s technical data (see chapter “Technical data”).
■
Lay the cord such that it is not crushed or creased and such that it does not come
into contact with hot surfaces.
■
Always set the rotary switch to the
AUS
(Off) position and pull the mains plug out of
the socket if a defect occurs while in use or before a storm.
■
If you want to remove the mains plug from the socket, never pull on the cable, but
always on the plug.
Beware of damage to the device and property
■
Check the device for damages prior to each use. Only use the device if it has been
completely assembled, is not damaged, and is fully functional!
■
Do not use any additional accessories. Only use the enclosed accessories from the
manufacturer.
■
Do not let the motor run if the device is empty.
■
Make sure that the maximum
fi
lling capacity (mark on the blending container) is not
exceeded!
■
Do not leave the device unattended when in operation.
■
The device must not be transported when switched on. Always pull the mains plug
out of the socket and allow the motor to come to a full stop prior to moving the device.
■
Do not allow the device to fall and do not subject it to strong percussions.
■
Do not subject the device to extreme temperatures, severe changes in temperature,
direct sunlight or moisture.
■
During operation, make sure the device has a stable position.
■
Always keep the lid of the blending container closed during preparation. You can
remove the insert in the centre of the lid to add ingredients during operation.
■
Use the device continuously for no more than 1 minute without stopping to prevent it
from overheating. Then, let the device cool off for a short time before using it again.
■
The motor unit is
not
suitable for cleaning in a dishwasher!
For your health
■
There may be some production residue stuck to the device. To avoid health risks,
clean it thoroughly before
fi
rst use (see chapter “Cleaning and storage”).
