EN
24
Use
CAUTION!
■
Never insert the blade attachments into the motor unit without a shaker / soup mixing
container.
■
Danger of damage due to insuf
fi
cient cooling!
Never place the motor unit on a
soft surface. The ventilation openings on the side and bottom of the motor unit must
not be covered.
■
Do not over
fi
ll the device!
Make sure that the maximum
fi
ll level (
MAX
marking in
the shaker / soup mixing container) is not exceeded!
■
Danger of damage from incorrect use of the accessories!
The device should only
be used if it has been completely and correctly assembled!
■
Danger of damage from unforeseen events!
Do not leave the device unattended
when it is in use.
■
Make sure that the device remains stable during operation. Always hold the motor
unit
fi
rmly with one hand.
■
The device may not be transported while it is switched on.
■
Read the “Using Accessories Correctly” chapter for details of the correct way to use
and assemble the accessories.
• The device has an automatic switch-off function. If no settings are made within
the space of 3 minutes in stand-by mode, the device switches off automatically.
To carry on working, switch the device back on by pressing the
Start / Stopp
(start/stop) button (
C
).
• The display (
A
) and the operating lamp (
7
) are only switched on if a shaker/
soup mixing container (
3, 11, 12
) has been
fi
tted on the motor unit correctly.
• A programme can be changed at any time during operation by pressing the
Funktion
(function) button (
B
) or be stopped by pressing the
Start / Stopp
(start/stop)
button (
C
).
Processing Cold Ingredients / Without Heating
CAUTION!
■
Danger of burns!
Never
fi
ll the small or large shaker with hot food or liquids! The
contents must not be hotter than 50°C.
When processing frozen fruit or vegetables, always pour a little liquid into the
shaker (
11, 12
) as well.
For all programmes, apart from
Erhitzen
(heating):
1. Place the motor unit (
5
) on a work surface:
– This must be dry, clean,
fl
at and not heatable.
– The suction feet (
8
) must stick to it
fi
rmly.
– Make sure that there is a suf
fi
cient gap from the edge of the work surface so that
the device does not fall off during operation.
