Software
Englisch, Revision 14, Date: 07.02.2017
35
Using „(
)isplay Telegram Content“ it is possible to check the generated telegram
(refer to Figure 16 on page 35). In this example the mask has the value 0xff. Press any
key to return to the menu
Serial Output
.
Figure 16
Output „(D)isplay Telegram Content“
The parameter “(
)har Delaytime“ is the so-called character delay for procedure
3964R (refer to appendix, section F „Procedure 3964R“ on page 55) and the time out
period for incoming characters for the transparent procedure (refer to appendix, sec-
tion G „Procedure „transparent““ on page 57).
either activates the permanent output, according to the
Clock for Sampling
set
in Time&Code (
1
; refer to 5.2.2.2 on page 33), or generates the output solely when a
transponder is decoded within the reading range of the antenna (
0
).
With
the repetition rate of the serial output is set.
S:0547 X:+0000 Code: 00000000 Read: 0
U[/mV]:24200 I[/mA]: 140 T[Grd.C]:+28 E: 0200 N: 0
Ftx[/Hz]:105960 Prog_Code: 00000000
STX 1 Bytes from Position: 1
CODE 4 Bytes from Position: 2
SUM_1 2 Bytes from Position: 6
Vcc 1 Bytes from Position: 8
Current 1 Bytes from Position: 9
Temp. 1 Bytes from Position: 10
CodesRd 2 Bytes from Position: 11
Status 2 Bytes from Position: 13
(Q)uit Menue
