Gotec SA, Rue des Casernes 59, CH-1950 Sion –
Tél. +41(0)27 205 7 205 - Fax +41(0)27 205 7 206 - e-mail :
-
www.gotec.ch
- 18 -
Connect
the
discharge
tube to the pump. The
hydraulic
discharge
connection uses flexible
tube having an inside Ø6
mm.
The electric cable must be
attached
to
the
anti-
wrenching support with a
cable tie.
Pre-form the refrigerant
tubes and position them in
the duct. Support the
tubes with the mounting
flanges provided.
Assembly on the left
Before closing the duct, it is advised to support the power cable and the
discharge tube between the insulation of the refrigerant tubes, so that
they do not touch the walls and the lid of the duct. This process will
help decrease the noise level of the installation.
Close the duct and fix the ceiling seal
with one screw (not supplied) or with
the double adhesive face which is on
the ceiling joint.
After testing the pump as described in
chapter 5, close the lid of the hull and
position the duct elbow.
Assembly on the left
ceiling joint
Assembly
on the left
