Hardware Maintenance
Before You Ride
7
Brake
Check the brakes for proper function. When you squeeze the lever, the brake should provide positive braking action. When you
apply the brake with the speed control on, the brake cut off switch should stop the motor. Make sure that the brakes are not
rubbing when lever is not being applied.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken frames are rare, it is possible for aggressive rider to run into a curb or
wall and bend or break a frame. Get in the habit of inspecting your scooter on a regular basis.
Tires
Periodically inspect the wheels for excess wear and always check and maintain tire inflation.
Safety Gear
Always wear proper protective gear such as an approved safety helmet. Elbow pads and knee pads are recommended. Always
Before you ride always check and for the following:
Safety Gear
Always wear proper protective gear such as:
•
Approved safety helmet. (Helmet may be legally required by local law or regulation in your area.)
• Elbow pads and knees pads
• Long sleeved shirt, long pants
• Gloves
• Lace up shoes with rubber soles.
Brake
Check the brakes for proper function. When lever is squeezed it should slow/stop the rear wheel without excessive effort. When
you apply the brake with the throttle on, the brake cut off switch should stop the motor. Make sure that the brakes are not rubbing
when the lever is not being squeezed. Do not ride the scooter if the brakes are not functioning properly.
Throttle
Make sure that before throttle is twisted that you are in an open and safe area to ride, you are balanced on the scooter and have
both hands on the handlebar controls.
Tires
Inspect the wheels for excess wear and replace if necessary. Always check and maintain tire inflation.
Frame, Fork and Components
Always carefully inspect your scooter before you ride. Check for cracks, broken worn or loose components which should be
repaired or replaced before you ride.
Battery
Always make sure the power switch is in the “off” position whenever the scooter is not in use. Never store the product in freezing or
below freezing temperatures. These low temperatures will permanently damage the battery.
WARNING:
Always ensure that you are in a safe open area to ride before you engage the throttle. Never twist
the throttle without being on the scooter in a balanced, ready to ride position with both hands on the handlebar
controls. Once the power switch is placed in the “on” position the scooter will move when the throttle is twisted.
Failure to follow these instructions may damage your scooter and void your warranty.
This product is NOT designed for road use.
