GORMAN-RUPP PUMPS 46141-053, Инструкция по установке, эксплуатации и техническому обслуживанию с перечнем запасных частей

Страница: 6 / 30

DIAPHRAGM PRIMER
OM-07297
PAGE A - 1 SAFETY
SAFETY ‐ SECTION A
This information applies to Gorman-
Rupp Diaphragm Primers. Refer to the
manual accompanying the pump and
power source before attempting to be­
gin operation.
Because pump installations are seldom
identical, this manual cannot possibly
provide detailed instructions and pre­
cautions for each specific application.
Therefore, it is the owner/installer's re­
sponsibility to ensure that applications
not addressed in this manual are per­
formed only after establishing that nei­
ther operator safety nor pump integrity
are compromised by the installation.
This manual will alert personnel to
known procedures which require spe­
cial attention, to those which could
damage equipment, and to those which
could be dangerous to personnel.
How­
ever, this manual cannot possibly antici­
pate and provide detailed instructions
and precautions for every situation that
might occur during maintenance of the
unit. Therefore, it is the responsibility of
the owner/maintenance personnel to
ensure that only safe, established main­
tenance procedures are used, and that
any procedures not addressed in this
manual are performed only after estab­
lishing that neither personal safety nor
pump integrity are compromised by
such practices.
Before attempting to open or service the
pump:
1. Familiarize yourself with this man­
ual.
2. Shut down the engine and discon­
nect the positive battery cable, or
lock out incoming power to the mo­
tor and take precautions to ensure
that the pump will remain inopera­
tive.
3. Allow the pump to completely cool
if overheated.
4. Check the temperature and make
sure the pump is cool before open­
ing any covers, plates, or plugs.
5. Close the suction and discharge
valves.
6. Vent the pump slowly and cau­
tiously.
7. Drain the pump.
Death or serious personal injury and
damage to the diaphragm primer or
components can occur if proper lifting
procedures are not observed. Make cer­
tain that hoists, chains, slings or cables
are in good working condition and of
sufficient capacity and that they are po­
sitioned so that loads will be balanced
and the diaphragm primer or compon­
ents will not be damaged when lifting.
Suction and discharge hoses must be
removed from the diaphragm primer be­
fore lifting. Lift the diaphragm primer or
component only as high as necessary
and keep personnel away from suspen­
ded objects.