Gorenje WDI73120 HK, Инструкция по эксплуатации

Страница: 15 / 24

EN
15
4.14 INTERRUPTING OR CHANGING THE WASHING PROGRAMME
The washing programme in progress can be interrupted at any moment:
1.
press the “Start/Pause” button for about 3 seconds: the display shows the word PAUS (for 1 second) al-
ternating with the time remaining until the end of the cycle (for 1 second). The Start/Pause light flashes
on and off.
Programmes can also be interrupted by turning the programme/temperature setting knob while the cycle
is in progress.
2. To change the washing programme, simply turn the programme knob to select the new programme;
there is no need to set the appliance in pause status. The new cycle will be carried out completely, be-
ginning from the start. If the tank had already been filled with water during the previous cycle, the water
intake phase will be omitted from the new programme.
3. If
End Time function
is activated and it wants to be terminated it can only be during
Pausing of the program (check point 1 in 4.14 paragraph). For terminating
End Time
function
check 4.12 paragraph.
4. To restart the cycle, press the Start-Pause button again.
4.15 PROGRAMME END
Washing/drying programmes are completed automatically. The word END appears on the display and the "Time
remaining" light goes out.
1. Switch the appliance off by turning the programmes knob to OFF
2. Unload the laundry from the drum.
3. Leave the door ajar to allow the interior of the washer-dryer to dry out.
4. Turn off the water intake tap.
If during the initial spin speed setting stage, the "no spin" mode with stop with tank full (spin speed set as 0)
was selected, at the end of the washing programme the word STOP appears on the display, alternating with ----
(spin speed of 0) and the spin light is on.
To proceed with the pump-out and spin, press the spin selection button twice. The appliance restarts the cycle
with the pump-out and spin. To select the spin speed required, press the button until the chosen speed is dis-
played. To pump out the water from the tank without performing the spin, press the spin selection button until the
display indicates speed of 0: the pump-out will be run without spin.
4.16 CHILD LOCK
1. When this function is activated, the modification of options, temperatures, spin speed and the wash-
ing/drying cycle is not possible while the cycle is in progress.
2. To activate the Child Lock, press the Option selection button and hold it down. Also press the Confirm
options button within 3 seconds.
3. The Child Lock symbol lights up to show that the function has been activated.
4. Repeat the same procedure to deactivate the function.
Child Lock Symbol
1
2