gorenje
S E R V I C I N G I N S T R U C T I O N S
WASHING MACHINES
4-022-0414
TEHNIČNA PRIPRAVA
SERVISNIH STORITEV
VILI GARNBRET
Gorenje, d.d.
3503 Velenje, p.p.107, SLOVENIA
Telephone: +386 63 8990 / 8992 432
Telefax
: +386 63 8992 794
STOP the program. The failure will be
displayed.
F5
the triac is short-circuited
The failure is set, if the washing program is
active and the motor is working without
control of triac. The washing program is
stopped immediately. . After 2 minutes try
again. If the failure is not present, than
forget the first failure and continue work. If
is the same failure again, than program
stops complete. If the temperature is higher
that 60°C than cool down with cold water
30 seconds. Then pumping water 2 minutes.
STOP the program. The failure will be
displayed.
On LCD:
ERROR 5
F6
temperature not reached
- heater defect
The failure is set, if after a heating step the
temperature is more than 15°C lower than
the rated temperature. The washing
program will be ended normally. The
failure will be displayed at the end of the
washing program.
On LCD:
ERROR 6
F7
the water level does not fall
below level 1
- pump clogged
- pump defect
The failure is set, if after a pumping step
the water level did not fall below level 1. If
the failure occurs the first time within a
washing program, the current step will
started again. If the failure occurs the
second time (twice in succession), the
washing program is stopped and the failure
is displayed. To continue the washing
program, the user has to press the „Start“-
button. If the failure occurred the third
time, the washing program is stopped and
the failure is displayed. It is not possible to
start the washing program again.
On LCD:
ERROR 7
F8
The WM not reach max.
spin speed (the tapped field
relay does not switch)
The failure is set, if at the end of the
spinning cycle of the testing program the
spin is more than 100rpm lower than the
rated speed. The failure is displayed after
the end of the testing program.
On LCD:
ERROR 8
F9
Water inside machine
(Aqua Stop)
The failure is set, if Aqua Stop Sensor
makes signal (must be measuring min. 2
seconds). All valves switch OFF, the
heater switches OFF and main motor
STOPS. After 3 seconds check again. If the
failure is not present, than forget the first
failure and continue with program. If the
failure is still present, than switch ON the
pump for 2 minutes and stop WM. The
failure is displayed. It is not possible to
start the washing program again.
On LCD:
ERROR 9
