
Legenda:
1 - Thermostat
2 - Thermal fuse
3 - Immersion heater
4 - Pilot lamp
5 - Connection terminal
L - Live conductor
N - Neutral conductor
- Earthing conductor
Electric installation
CAUTION: Prior to each reach in the inner of the heater you must absolute-
ly disconnect it from electric network!
USE AND MAINTENANCE
After the connection to water and electric network the heater is ready for use. By turning the knob of
thermostat at the front side of the protecting cover, the wished temperature of water 75
°C
is chosen.
We recommend the adjustment of the knob to the position "E". Such an adjustment is the most
economic, with it the temperature of water shall be approximately 55
°C
, the excretion of lime-stone
and thermal loss shall be smaller as by adjustment to higher temperature.
The operation of electric immersion heaters is shown by pilot light which is lit during the time until the
water in the heater is heating to the chosen temperature or to the intended switch off. During the heat-
ing the volume of water in the heater is increasing, which causes the dropping of water from the mix-
ing valve. By strong squeezing of the mixing valve the dropping can not be stopped but the mixing
valve can be damaged.
When the heater shall not be used during a longer time, its contents must be protected against freez-
ing so that the electricity shall not be switched off, but the thermostat knob shall be adjusted to the
position "*". With this adjustment the heater shall maintain the water temperature by approximately
9
°C
. But when the heater is switched-off the electric network, at risk for freezing, the water must be
emptied from it.
The outside of the heater is cleaned by mild solution of detergent. The solvents or rough cleaning
means should not be used.By regular service check impeccable operation shall be assured and a long
lifetime of the heater. The first check must be performed by authorised service workshop after approx-
imately two years after the first connection. At check, it necessary lime stone must be cleaned which
with regard to the quality, quality and temperature of the water used is gathered in the inside of the
water heater. Service workshop shall after check recommend also the date of next check.
Never try to repair any possible faults of the heater by yourself, but inform about it the
nearest authorised service workshop.
19
GB
Navodilo TEG - 382 012 646 - 08062004 copy.qxd 10.6.2004 8:57 Page 16
Содержание TEG 10 O
