Instructions for Use
6
Placing and Installation
Choosing the Right Site
Place the appliance in a dry and well ventilated
room. The room temperature should be between
10°C and 32°C.
Never place the appliance near anything that
emits heat(e.g. cooker, radiator, water heater or
similar devices) and do not expose it to direct
sunlight.
The appliance should be positioned at least 3 cm
away from an electric or gas cooker and at least
30 cm away from an oil or solid fuel range.
Behind the appliance there should be at least
2 cm of space with at least 5 cm above the fridge
freezer to ensure adequate ventilation of the
condenser.
Placing the Appliance
•
Place the appliance firmly and evenly on the
floor. Use the adjustable feet at the front to
level the appliance if necessary. If the fridge-
freezer is uneven then it may increase the noise
level in operation.
•
Two spacers attached to the appliance must be
fitted onto the upper edge of the condenser,
thus preventing the appliance from being
installed too close to the wall. Spacers are
manufactured for all-purpose function
depending on the distance of the condenser
from the wall. Therefore turn spacers
correspondingly and fix them to the appliance.
Connection to Power Supply
ELECTRICAL CONNECTION
For your safety please read the following
information
Warning: This appliance must be earthed.
The appliance must be connected to a 220-240
volts 50 cycle AC supply by means of a three pin
socket, suitably earthed and should be protected
by a 13 amp fuse in the plug or a15 amp fuse in
the consumer unit.
The appliance is supplied with a moulded 13 amp
3 pin mains plug fitted with a 13amp fuse. Should
the fuse require replacement, it must be replaced
with a fuse rated at 13 amp and approved to
BS1362.
The plug contains a removable fuse cover that
must be refitted when the fuse is replaced. In the
event of the fuse cover being lost or damaged,
the plug must not be used until a replacement
cover has been obtained.
If the moulded mains plug is unsuitable for the
socket outlet in your home or is removed for any
other reason, then the fuse should be removed
and the cut off plug disposed of safely to prevent
the hazard of electric shock.
There is a danger of electric shock if the cut off
plug is inserted into any 13 amp socket outlet.
How to wire a 13 amp plug.
Important
The wires in the mains lead on this appliance are
coloured in accordance with the following code:
Green and Yellow - Earth
Blue – Neutral
Brown – Live
As the colours may not correspond with the
markings identifying the terminals in your plug
proceed as follows.
The green and yellow wire must be connected to
the terminal in the plug which is marked with the
letter E or with the earth symbol or coloured
green and yellow.
The blue wire must be connected to the terminal
marked N or coloured black.
The brown wire must be connected to the
terminal marked L or coloured red.
