Gorenje IT 606 ASC, Инструкции по использованию, установке и подключению

Страница: 18 / 24

260938
• Cooking hobs can be installed into worktops that are 30 to 50
mm thick.
• If the board is thicker than 40 mm, its inner edge should be
trimmed, or ground (Figure A). Thus, suf fi cient air circulation
will be provided.
•
Worktop must be placed absolutely horizontal.
• Suitably protect the edges of the cut aperture.
• By means of the supplied screws 4 fasten the supplied
tightening brackets 4 fasten to the front and the rear side of
the cooking hob and to the prepared aperture.
• Connect the cooking hob to the mains power supply (see
instructions for the connection of the cooking hob to mains
power supply).
• Insert the hob into the cut aperture.
• Press the hob
fi rmly towards the worktop from above.
• For screwing down the fi xing clip it is not allowed to use
screws longer than 6,5 mm.
•
To enable normal operation of electronic components of the
induction hob, suf fi cient air circulation must be provided.
A Lower kitchen cabinet with a drawer
• An opening at least 140 mm high must be provided on the
back wall of the cabinet, along its entire width. Furthermore,
a minimum of 6 mm clearance must be provided at the front
side, along the entire width of the cabinet.
• The hob is fi tted with a fan located in its lower part. In case
there is a drawer underneath the kitchen cabinet, no small
objects or paper must be kept there, as these could be sucked
in by the fan, causing damage to the fan or the entire cooling
system. Aluminum foil and in
fl ammable substances or liquids
(e.g. sprays) should also not be stored in such drawers or
Installation procedure
Lower kitchen cabinet
ventilation slots
( )* - SIVK7
18
Worktop cutout
dimensions