Status light
Stopping or changing a programme
If you want to change programme after starting the
dishwasher, open the door then press and hold the main
power switch until the display turns off. Add more detergent
if the lid of the detergent dispenser has opened. Then press
the main power switch, choose a new programme and close
the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically. Add
the dishes and close the door. After a while, the dishwasher
continues the programme.
How to get the best drying results
•
Fully load the dishwasher.
•
Place the dishes in the machine so that the rinse water
will run off them; this is especially important for plastic.
•
Top up with rinse aid or increase the rinse aid dosage
level.
•
Activate the Auto open option.
•
Allow the dishes to cool before unloading the
dishwasher.
Once the programme has finished
The end of the programme is indicated by one short signal
from the buzzer. The chapter Settings describes how to
change this function.
Moreover, the end of the programme is indicated by the
status light turning off. See the section Status light in the
chapter Using the dishwasher.
The dishwasher switches off automatically after the
programme ends. Shut off the water tap after each use.
If the dishwasher is switched off using the
main power switch or during a power cut
If the dishwashing programme was not finished, the
interrupted programme continues when power is restored.
NOTE!
During drying, the programme is interrupted if the power
is cut or the door is open for more than 2 minutes.
7
