Gorenje GV61214, Инструкция по эксплуатации

Страница: 24 / 29

21
Positioning the Appliance
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bo wl or suitable
container that is held outside and lower th an the sink.
Water Outlet
Connect the water d rain hose. The d rain hose must be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or s quashed.
The following things should be checked before starting the dishwasher.
Syphon Connection
Insert the drain hose into a d rain pipe with a minimum diameter of 40mm, or let it run into th e sink, making sure to
avo id bending o r crimping it . The top of the ho se mus t be less than 100 0m m.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If you n eed a drain hose extension, make sur e to use a similar dra in hose.
It must be no longer than 4 metres; o ther wise the cleaning effect o f the dishwasher could b e reduced.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
3 There is a leakage at the connections of the conducts
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
Position the applianc e in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. T he dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate proper installation.
Please close the hydrant after using.
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and
the room, from severe splashing.
Unscrew The safety supply hose from the faucet..
2
1
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the
water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and
damage the appliance.
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it
is recommended thet the hose be disconnected and the hole plugged.
The safety supply hose consists of the double walls. The hose's system guarantees its intervention by blocking the flow of water
in case of the supply hose breaking and when the air space between the supply hose itself and the outer corrugated hose is full
of water.