Gorenje COMBI FS-600, Подробная инструкция по применению

Страница: 60 / 64

60
Problem: Cause or remedy:
Droplets on
the refrigerator
compartment back wall. • This is normal. The refrigerator compartment is
defrosted automatically, which results in droplets
of water that flows through an opening in the
refrigerator compartment back wall into a tray above
the compressor unit, from which it evaporates.
Water is dripping/
leaking from the
refrigerator: • Clogged water discharge opening or water
dripping past the water gutter.
• Clean the blocked opening, e.g. using a plastic straw.
• If a thick layer of ice builds up, defrost the
appliance manually (see Defrosting the Appliance).
The light above the set
temperature display will
flash (control unit 1). • Door opened too frequently or too long.
• Door not closed correctly (possible impurities on
the seal, misaligned door, damaged seal etc.).
• An extended power failure.
• Too much fresh food inserted at once.
Door is difficult to open: • If you are trying to open the freezer door after
just having closed it, this could be difficult to do.
As you open the door, some cool air escapes from
the appliance and it is replaced by warm air from
the environment. When this air is cooled, negative
pressure is generated which results in problems as
you try to open the door. After a few minutes, the
condition is normalized and the door can be easily
opened again.
Appliance sides are
warm. • This is normal. There are pipes and tubes installed
in the appliance sides, which tend to heat up
during appliance operation.
LED lighting does not
work: • If LED lighting does not work, call a service
technician.
• Do not attempt a repair of the LED lighting
yourself, as there is danger of contact with high
voltage!
Signal light above the
2, 3 or 5 indicator flashes
(control unit 1): • Temperature sensor error or fault. Call a service
centre for repair. Until the appliance is repaired by a
service technician, the appliance will operate in safe
mode. The appliance will automatically preserve the
most suitable temperature for each compartment.
Signal light above the
1 or 8 indicator flashes
(control unit 1): • Sensor keys are not responding. Call a service centre
for repair.
• Until the appliance is repaired by a service technician,
the appliance will operate in safe mode. The
appliance will automatically preserve the most
suitable temperature for each compartment.
814554