Gorenje BLG71112, Инструкция по эксплуатации

Страница: 13 / 16

237280
Cleaning the water condensation device
Water condensation device should be cleaned three to four times
a year, in case of very frequent use even more often.
During cleaning a certain amount of water may drip out so it is
good to put an absorbing cloth below the opening.
• Open the exterior lid of the condenser by grabbing the handle
on the lower left part of the appliance housing and pull it
downwards.
• Remove the interior lid by fi rst turning the lever vertically down,
then tilt the lid towards yourself and remove it.
• Turn the lock on the condenser upwards and pull the
condenser out by pulling the lever.
• Clean the device from both sides with lukewarm water and
drain it well.
• Before replacing it into its slot, clean the air channel in which
the device is mounted, and the gasket at the interior lid.
• Lock the condenser into its place.
• Insert the inner lid to seal well and lock it with a handle.
• Push the exterior lid towards the appliance to lock to its place.
After fi ve drying cycles you need to do the following:
• remove, clean/wash and re fi t the fi lters on the interior side of
the door and the bottom side of door opening;
• remove, clean/wash and re fi t water condenser;
• wipe the inside of the water condenser compartment with a
damp cloth;
• wipe the entire back of the water condenser housing with a
damp cloth (reach deeply into the condenser compartment
with your hand to touch the back wall of the compartment!);
• wipe all sealings and sealing surfaces of the condenser,
condenser housing and condenser door with a damp cloth.
• Periodically clean (vacuum) the interior of air evacuation
opening and evacuation tube.
Cleaning of Vented dryer Cleaning of Vented dryer
13