Gorenje Tiki KGV 400, Инструкция по эксплуатации

Страница: 28 / 48

28
Dear customer, thank you for purchasing our product.
PLEASE READ THE INSTRUCTIONS CAREFULLY PRIOR TO THE
INSTALLATION AND FIRST USE OF THE WATER HEATER.
The water heater has been manufactured in compliance with the relevant standards
and tested by the relevant authorities as indicated by the safety certificate. Basic
technical characteristics of the product are listed on the label attached to the
protective cover. The installation of the water heater must be carried out by qualified
staff only. All repairs and maintenance work in the interior of the water heater as
well as limestone removal or testing/replacement of the corrosion protection anode
may only be carried out by an approved maintenance service provider.
The water heater has been manufactured so as to allow alternative sources of
energy to be used, as follows:
- central heating hot-water system
- solar power
- heating pump.
INSTALLATION
The heater should be installed in a dry room that is not subject to freezing conditions,
preferably in the vicinity of other sources of heating (e.g. boiler room).
TECHNICAL CHARACTERISTICS
KGV 400-2 KGV 500-2
Heater volume [ l ] 385 500
Total mass [ kg ] 158 172
Rated pressure [ MPa ] 1
PT heated surface – lower [ m
2
] 1,8 2
PT heated surface – upper [ m
2
] 1
PT volume – lower [ l ] 11,3 12,6
PT volume – upper [ l ] 6,3
Type
Size in mm
Length of
anode in
mm
Size of
slope in
mm
H ΦD A B C E F G I J K L M N
KGV 400-2 1835 670 320 880 1000 1100 1460 345 1000 1521 910 1490 560 370 Φ33x750 1930
KGV 500-2 1853 750 370 930 1095 1195 1465 370 1095 1498 960 1465 560 310 Φ33x850 1970
PT - heat exchanger
GB