18
Operation
The hood is fitted with a control panel with aspiration speed
selection control and a light switch to control cooking area
lights.
Control Panel
1. Button ON/OFF light
2. Button ON/OFF Timer:
delayed switch-off of the
selected suction speed (power):
Suction speed (power) 1: 20 minutes
Suction speed (power) 2: 15 minutes
Suction speed (power) 3: 10 minutes
Intensive suction speed (power): 5 minutes
3. Button OFF / Decrease of suction speed (power)
4. Button ON / Increase of suction speed (power)
5. Display,
showing:
a. Suction speed (power):
LEDs
L1
–
L2
–
L3 - L4
(
flashing
)
light up according to the selected suction
speed (power).
Note:
the
L4
LED – intensive suction speed (power)
works for about 5 minutes, then the hood sets the
intermediate speed.
b. Timer:
the LED of the selected speed flashes to
indicate that the timer is active.
c. Grease filter saturation:
the
L3
and
L4
LEDs flash
alternately
at short intervals of time.
d. Activated charcoal filter saturation:
the
L3
and
L4
LEDs flash
simultaneously
at short intervals of time.
Reset of the filter saturation indicator: perform
filter
maintenance, then press button
2
until the LEDs turn off.
Note:
The activated charcoal filter saturation is normally
disabled and is enabled only if the hood is used in the filtering
version (with charcoal filter installed).
In order to activate it, proceed as follows:
- Switch
off
the
hood
-
Keep pressed simultaneously buttons
3
and
4
, until the
LEDs
L1
and
L2
flash briefly.
Repeat the operation to disable; only LED
L1
flashes briefly.
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
