
AQ-V-3M
5
OPERATING INSTRUCTIONS
Goodway AQ-V-3M duct vacuums are designed to pull loose debris out of the air
system to which they are connected and filter out harmful debris such as pollen,
dust, and mold spores with its 3 stage HEPA filter system.
Following are the steps necessary to operate the AQ-V-3M unit. Refer to the
maintenance section of this manual for the daily and pre-start maintenance check.
To test the AQ-V-3M, be sure all filters are in place and the top is closed and latched
in place, and the switch is in the off position. Connect the 12 gauge x 50 foot power
cord to an outlet. Once the power cord is properly connected, turn on the main
power switch.
Running new, the machine will most likely be running at 15 amps. To prevent
overheating, the AQ-V-3M will need to run between 12-13 amps. To do this, the
hose will need to be connected and the filters will need to have started
collecting dust.
MAINTENANCE AND STORAGE
The Filter Bag:
The filter bag should be cleaned after every duct cleaning job. To clean the filter
bag, remove it from the vacuum, empty the large debris into a proper waste
container, and then blow out the remainder of the debris or wash the filter bag.
Make sure there is no one else in the area if blowing out the remaining dust.
The Biostatic Wrap:
The filter bag should be cleaned after every duct cleaning job. To clean the biostatic
wrap, remove it from the vacuum, empty the large debris into a proper waste
container, and then blow out the remainder of the debris or wash the filter bag.
Make sure there is no one else in the area if blowing out the remaining dust.
The Main Cartridge Filter:
The main cartridge filter should be cleaned after every 2-3 duct cleaning jobs. To
clean the main filter cartridge, remove it from the vacuum, turn it upside down
over a proper waste container, and blow air through it from the inside out. Before
replacing, clean the inside of the housing that holds the filter.
Содержание AQ-V-3M
Страница 9: ...AQ V 3M 9 NOTES ...